Custom
Shapes/Patterns
Typical Material:
Suggested Materials (unless otherwise required):
For best quality:
Tungsten or Copper 0.001 inch think or
under
Gas, Liquid, Material FLOW Oriented:
Leak test Grade;
The emphasis normally on roundness is replaced by orifice area specification to improve cost-effectiveness. To optimize quality, materials should be kept as thin as allowable. 302 stainless steel is suggested unless otherwise required.
Metered Flow;
Same as Leak Test above.
Dies (wire polymer), Jets (liquid or gas);
Up to 0.010 inch (0.254mm) diameter x 0.001 inch (0.0245mm) deep
X-ray shielding, selective:
Typical materials are tantalum, tungsten and platinum.
Special Micro Patterns
Round, square, rectangular, slit,
arc, hexagon, octagon, annular, etc. and combinations of
patterns or arrays.
....per quote
Four-Bar Patterns:
Standards are: 302 stainless steel 0.0005 in. x 0.375 in., or copper 0.001 in.
Up to 5mm square; not including applicable air slit options
.......$85
Up to 0.750 in., any workable material
....per quote
SEM photos:
Per feature
....$95
Per additional shot/angle
....$25
(Not to be used for calibration or measurement
Shapes & Images
Quality projection samples are available at minimal or no cost.
Contact sales at1-800-360-4598
